Juniper Networks E-Series - Manual (Page 216)

APPENDIX B
Installing JUNOSe Software B-4
Task 3: Access Privileged Exec Mode
To access this mode via the CLI:
1
Issue the enable command.
host1>enable
2
Type the password if the system prompts you.
Task 4: Configure IP on an Interface
Typically, you configure IP on the Fast Ethernet interface of the SRP
module. To configure IP on an interface:
1
Determine the slot number of the module.
host1#show version
2 Determine the port number of the module.
3 Determine whether the interface already has an IP address.
host1#show ip interface fastEthernet 6/0
Note: If an IP interface is not configured, you see the message “Invalid interface.”
If the interface already has an IP address, go to step 5 . Otherwise,
proceed with step 4 .
4
Configure an IP address on the interface.
host1#configure
Configuring from terminal or file [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#interface fastEthernet 6/0
host1(config-if)#ip address ipAddress [ mask ]
5
Press <CTRL-Z> to return to Privileged Exec mode.
Task 5: Mount the CD on the Network Host
The way you mount the CD on the network host depends on the type of
computer you use, the operating system, and the network configuration.
To find out how to mount a CD on the network host, review the manual
for the operating system, or check with your network administrator.