JVC VN-C625 - Manual (Page 33)

33
PCs (users) connected to this camera are regulated via an access protection function
which requires a password entry.
Passwords can be set or canceled using the "VN-C625U Setup Tool".
A different password can be set for each of the 3 authorization levels, namely user, operator and administrator.
2-4 Other Settings Using the "VN-C625U Setup Tool" (1. Password Setting)
1.
Start up the "VN-C625U Setup Tool", followed by selecting [User], [Operator] or
[Administrator] under [Password] setting.
1 Enter a password to set password
protection or to change a password.
Characters entered are displayed as * .
• Enter the same password in both the
upper and lower boxes.
• Password must be alphanumeric and not
longer than 8 characters.
Click .
2 Click .
Authorization Level Allowed Access
User Viewing of motion images only
Operator All operations using the V.Networks Controller
Administrator All of the above and all settings using the VN-C625U Setup Tool
Note
Do not forget the passwords as canceling or changing of passwords is not possible unless the
current and correct password is entered.
2.
The following confirmation screen will be displayed.
Note
To cancel the password setting, leave
the entry box blank and click OK.
Notes
• For a password-protected VN-C625, a password request screen will be displayed.
• VN-C625 setup will not be possible unless the correct administrator password is entered.
• Security level increases in the order from user to operator to administrator. Password protection
will not be valid if a password is assigned only to a lower level but not to a higher one.
C625_p25-41 05.3.4, 5:29 PM 33