JVC VN-C625 - Manual (Page 42)

42
2-4 Other Settings Using the "VN-C625U Setup Tool" (4. Recording Setting)
● When an alarm is activated, recording can be performed via "local recording", where camera
images are saved into a CF card, or via the V.Networks Controller, where these are saved into the
hard disk of the PC.
☞
Page 82
Settings (Step 2 Network Settings)
This function is used to perform settings for local recording, which records camera images to
the CF card when the alarm is activated. Please purchase the CF card separately. (
☞
Page 22)
●
Setting the [Frame Rate] screen
1
2
4
3
●
Setting the [Trigger Recording] screen
1.
Start up the "VN-C625U Setup Tool" and select [Recording]. To make new values
effective, click on [Apply], followed by [OK].
Select alarm input signal “Trigger” for starting local
recording.
To set the frame rate for local recording, select "Change
the Recording Frame Rate during trigger recording",
followed by selecting the frame rate accordingly.
Default frame rate is set at 10 fps. A frame rate of 10
fps for recording will be used when this box is not
checked. (Set values: 30, 15, 10, 8, 6, 5, 4, 3, 2, 1)
Notes
During local recording to CF cards, the frame rate
is also dependent on the performance of the CF
card in use. When the size of each recording file
exceeds 8 MB (equivalent to a frame rate of 30 fps
over a duration of about 8 seconds when the size
of each image is 33 KB), frames may be dropped.
For setting the recording time.
This can be set up to 30 seconds before and 60
seconds after the alarm input.
Cautions
●
[Before trigger] and [After trigger] values cannot
be set to "0" at the same time.
●
Due to the memory capacity of VN-C625, recording
time set for [Before trigger] and [After trigger] may
differ from the actual maximum recording time.
(Example)
At a resolution of 640 x 480 (10 fps) when the
size of each image is 40 KB, the actual maximum
recording times are as follows:
Without CF card : 5 seconds before trigger / 10
seconds after trigger - 0
seconds before trigger / 15
seconds after trigger
With CF card : 20 seconds before trigger / 60
seconds after trigger
For setting the priority.
Frame Rate : Priority is given to frame rate settings.
Recording Time : Frame rate is automatically adjusted
such that recording can be performed
according to the specified recording
time.
VN-C625_p42-p57_2_24 05.3.4, 6:30 PM 42