JVC VN-C625 - Manual (Page 44)

44
2-4 Other Settings Using the "VN-C625U Setup Tool" (5. Private Mask Setting)
1.
Start up the "VN-C625U Setup Tool" and select [Private Mask].
The [Private Mask] screen will be displayed.
Settings (Step 2 Network Settings)
Use the Private Mask function to gray out areas on the screen that are to be excluded during shooting.
Up to 4 private masks can be set for each display screen and a total of 8 private masks for each camera.
(Controller Used for Private Mask Setting)
2.
When all the settings have been completed, click to end.
1
Set [Private Mask] to "ON".
(Default value: "OFF")
2
Select a number between Mask Nos. 1 to 8 to
perform private mask setting.
3
Click .
A controller for setting the private mask will be
displayed, and a mask area (gray color) will
appear on the live screen.
4
Move the mask area (gray color) to the center
of the area to be masked using the position pad.
5
Use the Size buttons to set the range of the
mask area.
6
Upon determining the mask area, click
to save the setting.
To set multiple mask areas, repeat procedures
from
2 through 6 .
Notes
●
Even when private mask is set, mask area (gray
color) will not be displayed on the screen in the
following cases.
• When the camera's tilt angle it 40˚ or larger.
• When there are 5 or more mask areas set on
the screen.
●
Objects within areas for which private mask has
been set may still be seen, depending on the
orientation of the camera and the zoom position.
As such, ensure that the range of area for which
private mask has been set cannot be seen by
moving the orientation of the camera and the
zoom position upon setting. In the case when
objects within the private mask area are seen,
enlarge the mask area.
●
The private mask function will not run properly
during the initial operation of the camera
immediately after its power has been turned on.
●
For screens that contain 5 or more preset
masks, the entire screen will be masked.
VN-C625_p42-p57_2_24 05.3.4, 6:30 PM 44