Siemens HIPATH 8000 - Manual (Page 2)

Safety Precautions
2
Safety Precautions
Important Notes
• This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful in-
terference when the equipment is operated in a commercial environ-
ment.
• This equipment generates, uses, and can radiate radio frequency ener-
gy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harm-
ful interference, in which case the user will be required to correct the
interference at his own expense.
• The IP telephone optiPoint 410/420 S V7.0 complies with the European
standard EN 60 950.
• The earpiece in this telephone handset contains a magnet. To prevent
injury, before each use ensure objects such as pins or staples are not
stuck to the earpiece.
• There is always the danger of small objects being swallowed by young
children. In the case of the optiPoint 410/420 S V7.0, this applies in par-
ticular to the connecting cord clip.
Please make sure that such items are not accessible to children.
• Never allow the telephone to come into contact with staining or corro-
sive liquids, such as coffee, tea, juice or soft drinks.
The information provided in this document contains merely general de-
scriptions or characteristics of performance features which in case of actu-
al use do not always apply as described or which may change as a result
of further development of the products.
Do not operate the telephone in environments where there is
a danger of explosions.
Use only original Siemens accessories. Using other accesso-
ries may be dangerous, and will invalidate the warranty and
the CE mark.
Never open the telephone or a key module. If you encounter
any problems, contact System Support.
7 Attention
If the optiPoint 410/420 S V7.0 is supplied with power over the LAN
interface Æ page 232, the power source must be a limited power
source PowerHub compliant with IEC 60950.