Siemens HIPATH 8000 - Manual (Page 82)

Extended Administration
82
Port Numbering
The phone will provide the ability to configure any TCP or UDP port number
that is currently fixed, with the exception of:
• SNMP
• SNTP
• DNS
• WAP Push
• WAP Push secure.
The table below gives the port addresses that will be configurable. The ta-
ble also shows the default values (see also RFC 1700 – Assigned num-
bers).
In some cases a port base number is used. The port base number will be
the configurable item, not the port numbers derived from the port number
base.
Function Default
Value
UDP
Default Value
TCP
Comment
RTP port range (local) 5004 to
5006 RTP port number is
even. RTCP port num-
ber is (RTP port num-
ber)+1.
5004 to 5006
reserved by IANA but
can be used by the
phone.
RTP port range (remote) any
RTCP port range (local) 5005 to
5007 RTP port number is
even. RTCP port num-
ber is (RTP port num-
ber)+1.
5005 to 5007 reserved
by IANA but can be
used by the phone.
RTCP port range (remote) any
HTTP - Hypertext Transfer Protocol 8085
HTTPS – Secure Hypertext Transfer Protocol 443
SNMP 161 Not configurable
SNMP Traps 162 Not configurable
SNTP 123 Not configurable
SNTP Heart-beat 580 Not configurable
DNS 53
DHCP Server port 67 Default BOOTP port
numbers. Not config-
urable