Quality of service (qos), Qos configuration – Siemens HIPATH 8000 User Manual
Page 58
![background image](/manuals/136200/58/background.png)
Extended Administration
58
Quality of Service (QoS)
By changing the Quality of Service parameter you can affect the speech
quality results. Further speech quality parameters see Æ page 93.
QoS Configuration
Primary DNS IP
Address
- 01=Network
- 08=Prim DNS IP addr
(change IP address)
- Network IP and routing
- Primary DNS IP address
(enter IP address)
Secondary DNS
IP Address
- 01=Network
- 09=Sec DNS IP addr
(change IP address)
- Network IP and routing
- Secondary DNS IP address
(enter IP address)
User specific
web ad
- 01=Network
- 12=User specific web ad
(switch on/off)
(not applicable)
Terminal
hostname
- 01=Network
- 13=Terminal Hostname
(change name)
- Network IP and routing
- Terminal hostname
(change name)
Use dynamic
hostname
- 01=Network
- 14=Use dynamic hostname
(mark to enable/disable))
- Network IP and routing
- Use dynamic hostname con-
cept
(mark to enable/disable))
Changing either the DHCP IP assignment or the Terminal IP address
will take effect as soon as the optiPoint 410/420 is restarted.
Parameter
Phone path
(Menu Æ page 148)
Web Interface path
(Menu Æ page 110)
QoS Mode
- 01=Network
- 06=QoS
- 2=QoS L2/L3
- 1=L2Off/L3Off or
- 2=L2Off/L3On or
- 3=L2On/L3On
- Quality of Service
- Required
(select QoS mode)
Layer 3 Voice
(only if L3On)
- 01=Network
- 06=QoS
- 3=L3 Voice
(select value)
- Quality of Service
- Layer 3 Voice
(select Layer 3 Voice value)
Parameter
Phone path
(Menu Æ page 148)
Web Interface path
(Menu Æ page 110)