Sunway NT 10000 - Manual (Page 44)

Setting the Date / Time
To set the time or date, select the menu
item «change settings» / «date/time», and
move to the «edit» mode by pressing the
RIGHT arrow key.
Setting the Display Language
To set the display language, select the
menu item «change settings» / «lan-
guage». Here, you can choose from the
languages German, English, Spanish,
French, and Italian by pressing the
UP/DOWN arrow key. Confirm your input
by pressing the RIGHT arrow key.
Setting the LCD Contrastt
If you wish to change the LCD contrast to
improve the clarity of the display, select
the menu item «change settings» / «LCD
contrast». Press the RIGHT arrow key to
activate the «edit» mode; then select the
desired contrast by pressing the UP/DOWN
arrow key. To confirm your input, press
the RIGHT arrow key.
Setting the Total Yield
If your Solar Inverter needs to be replaced,
you can take over the total yield from the
128
3.2 Configuring the Solar Inverter
You can enter the following settings in
your Solar Inverter:
· set RS485 address
· set date / time
· set display language
· set LCD contrast
· set total yield
Please note that the configuration can only
be changed when the Solar Inverter is ope-
rating. Alternatively, you can change these
settings by using the enclosed software
Sunways Monitor.
Setting the RS485 Address
To use the communication via the RS485
bus, the Solar Inverters must have consecu-
tive RS485 addresses. That means, if you
link three Solar Inverters together, their
addresses must be 1, 2, 3. When delivered,
address 1 is preset. To change the address,
select the menu item «settings» / «RS485
address», and press the RIGHT arrow key to
call up the «edit» mode. There, you can
enter an address from 1 to 99.
BP13370_NT_10000_englisch 23.11.2005 17:40 Uhr Seite 44