Ardo HX 080 X - Manual (Page 80)

461306975 (RS-000)
8
E
B C A
GB
ELECTRONIC PROGRAMMER "TOUCH" (ref. E)
Setting the time.
After connecting to mains or after a power cut, symbol
“A” and “0,00” will both fl ash simultaneously on the
display.
Keep pressed for some seconds simultaneously + and
- buttons or just MODE button, till when symbol “A”
turn off and symbol
turn on.
Time can be set just when the dot beneath the symbol
fl ashes.
Time cannot be adjusted during cooking program run.
If time is selected while a automatic cooking program
is running, this is deleted.
Program selection
Keep pressed for some seconds MODE button
and pressing it in turns, the following programs are
selected:
1. Minute Minder
The time turns off, the symbol turns on and
with + and - buttons is possible to select the time
alarm. At the end of the set time, the buzzer will
start and the symbol
fl ashes. To turn off the
buzzer and turn off the symbol keep pressed
for some seconds MODE button.
The minute minder program runs independently of
other cooking programs.
2. Semiautomatic Program with Duration or End
Time
Select with + and - buttons the duration. The time
of the day turns off, symbol “A” and “dur” fl ash. At
the end of the set time, the buzzer will start and the
symbol “A” fl ashes. To turn off the buzzer press
MODE button.
Now the oven is off. Keep pressed for some
seconds simultaneously + and - buttons or just
MODE button and the symbol
is illuminated.
3. Fully automatic program with Duration and End
time
Select with + and - buttons the duration and the
end time. The time of the day turns off, symbol “A”
and “End” fl ash. Symbol
turns off and the
symbol “A” turns on. The symbol is illuminated
again when the cooking starts. At the end of the set
time, the buzzer will start, the symbol
turns off
and the symbol “A” fl ashes. To turn off the buzzer
press MODE button.
Now the oven is off. To set the programmer on
manual operation keep pressed for some seconds
simultaneously + and - buttons or just MODE
button and the symbol
is illuminated.
Changing/Clearing programs
Each program can be cleared keeping pressed for
some seconds simultaneously + and - buttons. Symbol
“A” turns off.
Each program can be changed keeping pressed for
some seconds MODE button and then pressing it in
turns to the function to be changed. The adjustment
can be done with + and - buttons.
Is it possible to check whenever the progress of
program keeping pressed for some seconds MODE
button and then pressing in turns to the function to be
checked.
2. DESCRIPTION OF THE APPLIANCE