Ardo HX 080 X - Manual (Page 89)

17
461306975 (RS-000)
C
V
1
2
8
9
GB
OVEN SIDEWALL GRIDS (fi g. 8)
To allow for a better cleaning of the side grids, you can
extract them this way:
• Push with a fi nger on the last of the slots to release
the grid from its hold.
• Lift it towards the top and extract the grid.
To put them back into place, reverse the order of this
operation.
CHANGING THE OVEN LAMP (fi g. 9)
Attention!! Ensure the appliance is switched
off before replacing the lamp to avoid the
possibility of electric shock.
If the oven lamp needs replacing the new lamp must
have the following characteristics:
15 W - 230 Vac - 50 Hz - E 14 - resistant to high
temperatures (300°C).
To substitute the bulbs follow these instructions:
• Extract the side grids as indicated in the previous
paragraph.
• Remove protection cap (V) from bulb holder by
lifting it with a screwdriver (C) against the inside wall
of the oven.
• Substitute the bulb and reposition all elements back
by following the operation in reverse order.
3. USER INSTRUCTIONS
4. TROUBLESHOOTING
Some problems can be caused either as the results of simple maintenance operations or by incorrect selection
of settings. Prior to contacting a Service Engineer please check the following chart.
PROBLEM occurring SOLUTION envisaged
The oven does not work • Check that the plug is connected.
• Check that the programmer / clock is set for manual operation.
• Check the electrical system (fuse electricity board). If there is failure in
the system call an electrician.
During cooking the thermostat led
does not turn back on • Turn the thermostat round to a hotter temperature.
• Turn the selector round to a different function.
The oven light does not switch on • Turn the selector round to a different function
• Check that the oven bulb is properly fi tted
• If it has blown, buy a bulb specifi cally for high temperatures at a
Service Centre and fi t it following the instructions given on page 17.