Ardo HX 080 X - Manual (Page 91)

19
461306975 (RS-000)
V
V
11
GB 6. INSTALLER INSTRUCTIONS
TECHNICAL INFORMATION
All instructions related to installation and
maintenance operations listed in this section
must be carried out only by authorised
personnel.
The manufacturer cannot be held responsible
for any damage to persons or property resulting
from an incorrect installation of the appliance.
UNPACKING YOUR APPLIANCE
• Once the packaging has been removed, thoroughly
check that the appliance is in perfect condition. If you
have any doubts do not use the appliance and call our
Service Centre.
• Do not move the appliance by the handles.
• Some parts mounted on the appliance are protected
by a plastic fi lm. This protection must be removed
before using the appliance. We recommend slitting the
plastic fi lm along the edges with a sharp knife or pin.
All packaging materials used (cardboard boxes,
bags, polystyrene foam, nails, etc.) must be
kept out of the reach of children, as they are a
potential hazard source. All packaging materials
used are environmentally-friendly and recyclable
(wooden bits are free from chemicals, cardboard
is 80-100% recycled, protective bags are made in
polyethylene (PE), bands in polypropylene (PP)
and padding in polystyrene foam (PS) without
chloro-fl
uoro-carbides. Waste materials can
undergo treatment and be recycled saving on
new raw materials and on the amount wasted
volumes. For this purpose we suggest you take
the packaging material back to the shop you
bought the appliance or to a collecting service.
Ask your local service for the nearest service.
WARNINGS
• As this is a built-in oven, please ascertain that
the walls or panels surrounding the appliance
can withstand a temperature of over 70 K.
• Also make sure that the glue that joins the
laminated plastic coat to the unit can withstand
a temperature of around 150°C, to avoid the
laminated coat to unglue.
INSTALLING AND FIXING THE OVEN
The oven can be housed into a cabinet or into a base
module, making room for its volumes as shown in
fi g. 10.
To guarantee proper aeration of the heat remove
the rear panel of the base module or make an
escape opening (A), as shown in fi g. 10.
Fit the appliance in place and secure it with the screws
supplied (V) (fi g. 11).
The oven must stand on a solid platform that
will withstand its full weight, as screws are only
used to secure the appliance inside its cabinet
housing.