Sanyo PLC-XL40 - Manual (Page 13)

13
Part Names and Functions
1 2 3
To insure safe operation, please observe the following precautions:
● Use two (2) AA or LR6 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid matter.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
● Risk of explosion if a battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.
Open the battery
compartment lid. Install new batteries into
the compartment. Replace the
compartment lid.
Two AA size batteries
For correct polarity (+ and –),
be sure battery terminals are
in contact with pins in the
compartment.
Point the remote control toward the projector
(Infrared Remote Receiver) when pressing any
button. Maximum operating range for the
remote control is about 16.4’ (5 m) and 60
degrees in front of the projector.
Operating Range
30°
30°
Remote Control Battery Installation
16.4’
(5 m)