Sanyo PLC-XL40 - Manual (Page 26)

26
Press the INPUT button on the top control or the
COMPUTER button on the remote control to select either
Computer 1 or Computer 2.
Before using the INPUT or COMPUTER buttons, select the
correct input source through Menu operation as described
below.
Press the MENU button to display the On-Screen
Menu. Use the Point
7 8 buttons to move the red
frame pointer to the Input Menu icon.
1
Input Menu
Use the Point ed buttons to move the red arrow
pointer to either Computer 1 or Computer 2, and then
press the SELECT button.
2
After the Source Select Menu appeared for Computer
1, move the pointer to RGB and then press the
SELECT button. 3
Input Menu
COMPUTER button
Computer 1
Computer 2*
Input Source Selection
Direct Operation
Menu Operation
Computer Input
Move the pointer (red arrow)
to Computer 1 and press the
SELECT button.
Input Menu icon
Move the pointer (red arrow)
to Computer 2 and press the
SELECT button.
Move the pointer to RGB
and press the SELECT
button.
Source Select Menu
Remote Control
COMPUTER button
✔
Notes:
•Computer 2 is not displayed when the COMPUTER IN
2/MONITOR OUT terminal is set as Monitor out (p.45).
•Computer 2 (COMPUTER IN 2/MONITOR OUT) can accept only
the RGB signal.
Computer 1
Video
Computer 2*
INPUT button
Top Control INPUT button
ON
- OFF
POWER
KE INPUT
WARNING LA
MENU
SELECT
Computer
1
*See Notes at the bottom of this page.