Sanyo PLC-XL40 - Manual (Page 59)

59
Appendix
The CE Mark is a Directive
conformity mark of the European
Community (EC).
Some displays are not seen – Check the Display function (see page 42).
during the operation.
PIN code dialog box appears – PIN code lock is being set. Enter a PIN code; the “1234” or numbers
at start-up. you have set (see pages 19, 47–48).
Computer 2 cannot be selected. – Select Computer 2 in the Terminal function (see page 45).
The Terminal function cannot be – The Terminal function cannot be selected after Computer 2 is
selected. selected. Select other input source such as Computer 1 or Video
with the COMPUTER button or the VIDEO button on the remote
control so that the Terminal function can be selected.
The Remote Control does not – Check the batteries.
work. – Make sure no obstruction is between the projector and the remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4’ (5 m).
– Make sure the code of the remote control is conformed to that of
the projector (see page 46).
– Unlock the Key lock function for the remote control (see page 47).
Cooling fans are still running after – This is a normal condition. The fans keep running for a certain time
the AC plug is disconnected. even after disconnecting the AC plug.
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased the