Sanyo PLC-XL40 - Manual (Page 51)

51
Antitheft Alarm Function
CAUTION:
WHEN YOU HAVE CHANGED THE PIN CODE, WRITE
DOWN THE NEW PIN CODE AND KEEP IT SECURELY. IF
YOU FORGET YOUR PIN CODE, SOME SETTINGS OF
THE ANTITHEFT ALARM FUNCTION CAN NO LONGER
BE CHANGED.
Change the PIN code
Press the F button and enter the four-digit PIN code
number within about 10 seconds. The ALARM
indicator blinks red for a few seconds and a high-
pitched confirmation sound is produced.
Other settings
Reset the settings
Select Factory default in the Setting menu to reset the
settings for the Antitheft alarm function.
Side Control
1
2 While the indicator is blinking, enter a new PIN code,
then you will hear a high-pitched confirmation sound
and the ALARM indicator is turned off.
When entering an incorrect PIN code, you will hear a
low-pitched sound. If you enter incorrect PIN code
three times in a row, the alarm starts ringing.
The PIN code for the Antitheft alarm function is a
combination of 1, 2, or 3. Use the buttons 1, 2, and 3
to enter the PIN code. The default PIN code is set to
“1111.”
✔
Note:
•This is effective only when the Antitheft alarm setting is released.
ALARM
indicator
F button button 1, 2, 3
The Alarm operating configuration can be changed when
the Antitheft alarm function is set to “Off.” See page 50 to
set or release this function.
Press the SELECT button at Alarm icon in the Setting Menu
to display the Alarm setting dialog box. Use the Point
ed
buttons to select Alarm volume, Sensitivity, or Ringing time,
and set each item with the Point
7 8 buttons.
Alarm volume
Small, Medium, Large
Sensitivity
Low .....................Less sensitive
Medium ..............Normal sensitivity
High ....................Highly sensitive (default)
Ringing time
10 seconds .........Rings about 10 seconds (default).
60 seconds .........Rings about 60 seconds.
Long time ............Rings until the end of the battery life.
Alarm
Press the SELECT button at
the Alarm icon to display the
Alarm setting dialog box.
✔
Notes:
•The Alarm icon appears dimmed and can be
unavailable when the Antitheft alarm function is
set to “On” or if the battery is not installed or it
is coming to the end of its life.
•While the Alarm icon is selected, the Antitheft
alarm setting buttons on the side panel can be
unavailable.
•When selecting “Long time” option in the
Ringing time, the duration of alarm sounding
differs depending on the battery life.
Set the Alarm volume,
Sensitivity, or Ringing
time with the Point
7
8 buttons.
Alarm operating configuration