Sanyo PLC-XL40 - Manual (Page 19)

19
Connect the projector’s AC power cord into an AC
outlet. The POWER indicator turns red.
Press the POWER ON-OFF button on the top control
or on the remote control. The POWER indicator
becomes green and the cooling fans start to operate.
The preparation display appears on the screen and the
count down starts.
2
3
1
16
The preparation display disappears after 30 seconds.
4 After the countdown, the input source that was
selected the last time and the Lamp mode status icon
(see page 46) will appear on the screen.
If the projector is locked with a PIN code, a PIN code
Input Dialog Box appears. Enter the PIN code as
instructed below.
See page 46 for the Lamp mode.
Selected Input Source and Lamp Mode
Complete peripheral connections (with a computer,
VCR, etc.) before turning on the projector.
Lamp mode
Pointer
After the OK icon
disappears, you can
operate the projector.
PIN Code Input Dialog Box
Turning On the Projector
Basic Operation
Enter a PIN code
Use the Point 7 8 buttons to select a number and press the
SELECT button to fix the number; the number changes to
“
✳.” If you fixed an incorrect number, move the pointer to
“Set” or “Clear” once with the Point d button, then return
to “PIN code.” Enter the correct number.
Repeat this step to complete entering a four-digit number.
“1234” is set as the initial PIN code at the factory.
When the four-digit number is fixed, the pointer
automatically moves to “Set.” Press the SELECT button so
that you can start to operate the projector.
If you entered an incorrect PIN code, “PIN code” and the
number (
✳✳✳✳) will turn red and disappear. Enter the PIN
code all over again.
What is PIN code?
PIN (Personal Identification Number) code is a security code
that allows the person who knows it to operate the
projector. Setting the PIN code prevents unauthorized use
of the projector.
A PIN code consists of a four-digit number. Refer to PIN
code lock function in the Setting Menu on pages 47–48 for
locking operation of the projector with your PIN code.
✔Notes:
•When the Logo select function is "Off,” the logo
will not be displayed on the screen (p.43).
•When the "Countdown off" or "Off" is selected in
the Display function, the countdown will not be
shown on the screen (p.42).
•During the countdown period, all operations are
invalid.
•If the correct PIN code number is not entered for
3 minutes after the PIN code dialog box
appeared, the projector will be turned off
automatically.
CAUTION ON HANDLING THE PIN CODE
If you forget your PIN code, the projector can no
longer be started. Take special care in setting a
new PIN code; write down the number and keep it
at hand. Should the PIN code be missing or
forgotten, consult your dealer or service center.