Sanyo PLC-XL40 - Manual (Page 35)

35
Press the INPUT button on the top control or VIDEO button
on the remote control to select “Video.”
Before using INPUT or VIDEO buttons, select the correct
input source through menu operation as described below.
Use the MENU button to display the On-Screen Menu.
Press the Point
7 8 buttons to move the red frame
pointer to the Input Menu icon.
Use the Point ed buttons to move the red arrow
pointer to Video and then press the SELECT button to
display the Source Select Menu .
1
2
Move the pointer to Video
and press the SELECT
button.
VIDEO
Move the pointer to the
desired source and press
the SELECT button.
Source Select Menu (VIDEO)
Input Menu
Move the pointer to the desired source that and then
press the SELECT button. 3
When selecting “Auto,” the projector
automatically detects the incoming video signal,
and adjusts itself to optimize its performance.
The projector selects connection in the following
order:
1. S-Video
2. Video
Auto
When the video input signal is connected to the
VIDEO jack, select Video.
Video
When the video input signal is connected to the
S-VIDEO jack, select S-Video.
S-Video
Input Source Selection (Video, S-Video)
Direct Operation
Menu Operation
Input Menu icon
Video Input
Remote Control
VIDEO button
INPUT button
Top Control
INPUT button
ON
- OFF
POWER
KEYST
ON
INPUT
WARNING LAMP RE
MENU
- VO
+ VO
SELECT
Video
Computer 2*
Computer 1
✔
Note:
•Computer 2 is not displayed when the COMPUTER IN
2/MONITOR OUT terminal is set as Monitor out (p.45).
*See Note at the bottom of this page.