Sanyo PLC-XL40 - Manual (Page 20)

20
Basic Operation
Press the POWER ON-OFF button on the top control
or on the remote control, and “Power off?” appears on
the screen.
Press the POWER ON-OFF button again to turn off the
projector. The POWER indicator starts to blink red, and
the cooling fans keep running. (You can select the
level of the fans’ quietness and running speed. See
page 49.) At this time you can disconnect the AC
power cord even if the fans are still running.
1
2
TO MAINTAIN THE LAMP LIFE, ONCE YOU TURN
THE PROJECTOR ON, WAIT AT LEAST 5 MINUTES
BEFORE TURNING IT OFF.
3 When the projector has cooled down enough to be
turned on again, the POWER indicator stops blinking.
“Power off” disappears after 4 seconds.
✔
Notes:
•When the On start function is “On,” this projector is turned on
automatically by connecting the AC power cord to an AC outlet (p.
46).
•Do not operate the projector continuously without rest. Continuous
use may result in shortening the lamp life. Turn off the projector
and let stand for about an hour in every 24 hours.
•The running speed of cooling fans is changed according to the
temperature inside the projector.
•Do not put the projector in a case before the projector is cooled
enough.
•If the WARNING indicator blinks or emits a red light, see “Warning
Indicator” on page 53.
Turning Off the Projector