Data transmission, System requirements, Software installation and setup – Sharp O2 User Manual
Page 112: Using the modem setup
111
Data Transmission
Data Transmission
Your PC can be set up to use the GX1 as a modem. You
can use Infrared (IrDA) to connect to the PC.
System Requirements
OS: Windows
®
98*, Windows
®
Me,
Windows
®
2000, Windows
®
XP
* Windows
®
98 Second Edition, or Windows
®
98 +
Internet Explorer 5.01 or later
Interface: Infrared (IrDA) or Serial port (D-sub 9-pin
connector)
CD-ROM drive
Software Installation and Setup
1. Install Modem setup software from the included
CD-ROM.
• Insert the CD-ROM and double-click [setup.exe]
to start installation.
• Follow the instructions on the screen to complete
installation.
When installation has completed, “SHARP GSM
GPRS” icon appears in the control panel.
When you perform the following operations (step 2
to 4), refer to GSM/GPRS Modem Option Help
after executing [SHARP GSM GPRS] in the control
panel.
2. Install Modem driver.
3. Make the Dial-up connection.
4. Set GSM/GPRS Modem Option which is stored in
the control panel.
If you wish to use GSM, fill the GSM connection
column.
If you wish to use GPRS, fill the GPRS connection
column.
Note
• Modem setup software may not run on certain PCs.
Using the Modem Setup
The software in the CD-ROM supplied is provided
based on the END USER LICENSE AGREEMENT,
and can be used and duplicated only in compliance
with the conditions of the pertinent END USER
LICENSE AGREEMENT.
The software installer displays the END USER
LICENSE AGREEMENT upon startup.