Remote control – Kathrein UFS 902 User Manual
Page 11
11
REMOTE CONTROL
REMOTE CONTROL RC 660
The RC 660 remote control supports up to four units which are supplied as standard with the RC 660.
First switch off all other receivers at the power switch.
1. Set-up using menu
On the UFS 902 the remote control code on the “Service Menu”, “Remote Control Code” menu is changed.
Note:
The remote control code can only be changed using the menu. Manual changes are not
saved by the receiver.
2. Manual set-up (not possible on UFS 902)
Switch on the relevant receiver.
On the remote control simultaneously press
address 1 =
+
+
Then switch the receiver off again at the power switch and do the same for the other units (
+
+
for the second receiver;
+
+
for the third receiver and
+
+
for the fourth receiver)
Make sure only one receiver is on at a time!
To switch the remote control to an infrared code:
When you have confi gured all receivers to their infrared code, to switch between units on the remote
control do the following:
For operating the fi rst receiver (address 1), press
+
, for the second receiver
+
, for the
third receiver
+
and for the fourth receiver
+
.
+
(red)
= Kathrein UFD 5xx code for remote control RC 400
The RC 600 and RC 650 remote controls are not interchangeable!