Kathrein UFS 902 - Manual (Page 9)

9
CONNECTION AND SETUP
Connect the satellite receiver (HDMI or alternatively TV Scart socket) and the TV set using a HDMI or
Scart cable (see “Connection Example”). If your TV is stereo, you can receive the sound in stereo via
the HDMI or Scart connection.
For system reasons, the same video signals are to be found at the TV Scart socket as at the video
cinch output.
If you want to play the sound on your hi-fi system, connect the audio cinch sockets to the input sockets
on the hi-fi system, using an appropriate cable (see “Connection Example”).
The fi bre-optic output is intended for the connection of a Dolby Digital system (see “Connection Example”).
Remove the cover on the rear of the remote control.
Insert the two batteries supplied into the remote control. Ensure correct polarity of the batteries;
the + and - markings are indicated inside the battery compartment.
Slide the cover back into the housing until it locks in place.
TV CONNECTION
AUDIO CONNECTION
OPTICAL/ELECTRICAL DIGITAL OUTPUT
INSERTING BATTERIES IN THE REMOTE CONTROL