Kathrein UFS 902 - Manual (Page 16)

16
FIRST INSTALLATION: DiSEqC™1.0
LNB Type
Here use the

buttons to select the LNB type used in your system. The choice is between
“Universal” and “user-defi ned”.
Universal:
No further input is required, since all necessary frequency ranges are covered by a universal LNB.
user-defi ned:
If you choose not to use a universal LNB, you must here set the frequency ranges for which your LNB
was confi gured.
Use the

buttons to select the frequency range to be changed (low, high or limit frequency).
Use the

buttons or the number buttons to set the exact frequency for which your LNB was
confi gured.
Test transponder
To check whether the settings that you have made are correct, use the

buttons to move to the
“Test transponder” fi eld. Use the

buttons to select the various transponders. If your settings are
correct, you will see at the top right of the screen the live signal of a channel for the currently selected
transponder.
If you are not receiving a signal, check your settings again and if necessary call for expert help.
You have now completed all settings for the fi rst satellite. Press the

button to return to the “Antenna
Confi guration Menu” and perform the settings in the same way for the remaining satellites.
When you have fi nished confi guring the satellite press
!
(green). The receiver then automatically opens
the menu for the channel search. Continue with the section (Execute channel search).