Kathrein UFS 902 - Manual (Page 21)

21
FIRST INSTALLATION: Single-cable system (automatic)
The receiver searches for the transmission channels
on your single-cable system and shows in the next
display the available transmission channels.
Use the

buttons to select the transmission
channel you want and confi rm the selection with
the button.
The receiver now reads the existing system data for
your single-cable system and confi gures itself.
The receiver has been successfully registered on
your single-cable system. Confi rm the display with
the button. Now press the
!
(green) button.
The receiver will automatically display the menu for the
channel search. Continue with the section (Execute
channel search).
If no connection to the single-cable system could be established, you will receive the message
“Registration was abortive!”. Check your settings and if necessary call for expert help.
If one or more receivers are already present on the system and an additional
receiver is to be connected, when assigning the transmission frequency for the new
receiver make sure that no transmission frequencies are duplicated. No frequency
can be used by more than one receiver.
No frequency can be used by more
than one receiver.
The receivers would interfere with
each other.