Kathrein UFS 902 - Manual (Page 45)

45
Use the

buttons to switch to the selection fi eld “End” and use the

buttons or the number
buttons to select the desired recording end time.
When all settings have been made, press the button to save the recording settings. You can view
the scheduled recording in the timer list view of the EPG (see section “Timer list”).
SERIES RECORDING
Use the

buttons to select the recording mode “Series recording”.
In series recording the start and fi nish of recording are taken automatically by the receiver from the
EPG data. You can specify only a single value for the lead-in and run-on time to be sure to record the
complete programme even if transmission times may vary slightly. The lead-in and run-out time is set
using the

buttons or the number buttons.
When all settings have been made, press the button to save the recording settings. You can view
the scheduled recordings in the timer list view of the EPG (see section “Timer list”).
Series recording depends on the EPG data being kept up to date at all times. The
receiver automatically updates the EPG data when the unit is switched off by
pressing the

button. Updating is important because it enables the receiver
to recognise for purposes of recording any changes to scheduled transmission
times of the series, provided these were incorporated in the EPG data supplied
by the channel provider in advance of the latest EPG update.
EPG - ELECTRONIC PROGRAMME GUIDE