Service menu – Kathrein UFS 902 User Manual
Page 71
71
USB DEVICE MANAGEMENT
This function is not currently supported/activated.
SERVICE MENU
REMOTE CONTROL CODE
Select the “Service” menu using the menu button
, the
buttons on the main menu and
.
Use the
buttons to switch to “Remote Control Code” and to open press the
button.
The following display appears:
You can now use the remote control for your receiver to set a new remote control code.
Simultaneously press buttons
+
+
for remote control code 1 (standard setting)
+
+
for remote control code 2
+
+
for remote control code 3
+
+
for remote control code 4
After changing the remote control code you must now set your remote control to the code you selected.
For this, simultaneously press buttons
+
for remote control code 1
+
for remote control code 2
+
for remote control code 3
+
for remote control code 4
Then press the
button. If the receiver display does not close down, the receiver and the remote
control are not set to the same remote control code. Check your settings again.