Kyocera KM-C2030 - Manual (Page 12)

1.2 Available Features 1
1-5
B
e
fo
re
Ma
ki
ng C
opi
es
Ch
apte
r 1
Finishing Settings
Stapling
Copies are stapled together before they are fed out.
Stapling is only available if the optional finisher (DF-625 or DF-620) is
installed.
Hole-punching
Holes are punched in copies before they are fed out.
Hole-punching is only available if the punch kit (PH-620) is installed
in the optional finisher (DF-625).
Zoom Settings
Auto Size
● This setting automatically selects the most appropriate zoom ratio based on the
size of the document loaded and the specified paper size.
Full Size
● This setting makes a copy that is the same size as the document (
× 1.000).
Enlarged copies
● Zoom settings for making enlarged copies from common standard document
sizes to standard paper sizes are available.
❍ Example 1: A Letter-size document can be copied onto the larger 11 × 17-size
paper.
❍ Example 2: A Legal-size document can be copied onto the larger 11 × 17-size
paper.
Reduced copies
● Zoom settings for making reduced copies from common standard document siz-
es to standard paper sizes are available.
❍ Example 1: A Legal-size document can be copied onto the smaller Letter-size
paper.
❍ Example 2: An 11
× 17-size document can be copied onto the smaller Letter-
size paper.
Minimal
● This setting slightly reduces the copy (
×0.930).
❍ Selecting the “Minimal” setting ensures that any part of the original positioned
at the edge of the page will not be cut off in the copy.
Zoom copies
● Any zoom ratio (between ×0.250 and ×4.000) can be specified.
❍ Touch and to specify the desired zoom ratio.