Kyocera KM-C2030 - Manual (Page 24)

1.5 Turning the Copier On and Off 1
1-17
B
e
fo
re
Ma
ki
ng C
opi
es
Ch
apte
r 1
● The conditions for all modes and functions automatically returning to their de-
fault settings can be specified using the “Auto Panel Reset” function on the Us-
er’s Choice: 1 screen. For more details, refer to “Specifying Default Settings
(“User’s Choice” Functions)” of “Utility Mode Operations” in the Administrator
Operations volume.
Energy Saver Mode
If the copier is not used for 15 minutes, it automatically enters Energy Saver mode.
When the copier enters Energy Saver mode, the indicator on the [Start] key remains
lit in green and the touch panel goes off. The copier conserves energy and waits to
receive a job.
If the copier is not used for 30 minutes, it automatically enters Sleep mode.
The length of time after the last operation until the copier enters Energy Saver mode
can be specified using the “Energy Saver” function on the User’s Choice: 1 screen.
For more details, refer to “Specifying Default Settings (“User’s Choice” Functions)”
of “Utility Mode Operations” in the Administrator Operations volume.
To recover from Energy Saver mode
1 Press the [Start] key. (The Energy Saver mode can also be canceled by
pressing any key on the operation panel or by touching the touch panel.)
2 The touch panel comes on again, and then after the copier has finished warming
up, it is ready to begin printing (after about 30 seconds at normal room temper-
ature (68°F)).
Sleep Mode
If the copier is not used for 30 minutes, the copier automatically enters Sleep mode.
The length of time after the last operation until the copier enters Sleep mode can
be specified using the “Sleep” function on the User’s Choice: 1 screen. For more
details, refer to “Specifying Default Settings (“User’s Choice” Functions)” of “Utillity
Mode Operations” in the Administrator Operations volume.