Kodak 500 - Manual (Page 122)

A-61628 December 2011 6-5
NETBIOS usage — in network environments that use routers it is
common practice to block NETBIOS traffic on your router. You may
need to know the IP address of the server where you want to scan
documents. By substituting the IP address of the server instead of the
NETBIOS computer name, you can bypass the network traffic
restrictions that may cause network scanning to fail. For example, the
previously defined network address: \\acmeserver\scanfolder should be
replaced with something similar to: \\192.168.2.10\scanfolder.
Updating your Scan
Station
There are four ways to update your Scan Station:
• Method 1. Uploading using the KSS500 - Scanner Admin
application. The Scan Station will automatically recognize the new
configuration data or update package and perform an update
automatically. See the section entitled, “Method 1” later in this
chapter for more information.
• Method 2. The administrative configuration file and optional update
package is stored on a network drive and the Scan Station is
configured to poll this shared folder at a specific day and time for
updates. See the section entitled, “Method 2” later in this chapter for
more information.
• Method 3. The administrative configuration file is stored on a USB
drive, inserted into a Scan Station, which is then updated. This
method is manual and must be repeated for each Scan Station on the
network. See the section entitled, “Uploading configuration settings
using a USB drive” in Chapter 3 for more information.
• Method 4. The administrative configuration file is stored on a USB
drive with an update package. This causes the Scan Station to be
updated with new firmware. See the section entitled, “Method 4” later
in this chapter for more information.