Kodak 500 - Manual (Page 125)

6-8 A-61628 December 2011
Method 2 The Scan Station software can be configured to monitor a network
folder where configuration files and firmware updates are installed. To
set this up:
1. From the Configuration Organizer Settings screen, select the
Device icon and click Remote Configuration Settings.
From this screen, you can select and define the following values:
• Path to the folder where updates can be found.
• Which day of the week (Every Day, Every Monday, Every
Tuesday, etc.).
• The time of day to check for updates (a 24-hour clock).
For example, you may want to monitor the folder
\\myserver\updates\myscanstationID on Every Monday, at 7:00 a.m.
There are two ways to remotely configure and update your Scan
Station:
• Single file/folder update — create a single folder on the network
where all Scan Stations are configured to monitor for updated
configuration files. This way allows you to send a single configuration
to all of the Scan Stations on a network at one time. This is
recommended when all of your Scan Stations share the same
configuration.
NOTE: When using remote update, some configuration settings
(Device name, IP address and Device Password), are
ignored to avoid creating duplicate devices on your network.
• Multiple files/folder update — if each of your Scan Stations require
a different configuration, it is recommended that a common folder is
created on the network with subfolders underneath to store individual
configuration files for each Scan Station on your network. Each Scan
Station should then be configured to monitor the appropriate folder
for updates.