Kodak 500 - Manual (Page 84)

4-24 A-61628 December 2011
Verifying your Scan
Station setup Verify that your Scan Station installation was successful and is
operational.
NOTE: If Save to Flash Drive is disabled, select another destination to
scan to and go to Step 3.
1. Insert a blank USB drive in the Scan Station’s USB port.
When the Scan Station recognizes the USB flash drive, an icon is
displayed showing the USB flash drive with the user profile.
2. Click Save to Flash Drive.
3. Place a document into the input tray and press the Go button. The
Destination Review screen will be displayed.
NOTE: If you enabled FAST Scanning, the Scan Station will start
automatically and the Settings Review screen will not be
displayed. Otherwise, the Scan Station will begin scanning
after 10 seconds (or you can press the Go button again to
start scanning immediately).
As the Scan Station begins to feed and process documents, a
Status screen will be displayed. The page number and a preview
image will be displayed as each page is being scanned.
When the document has been scanned, the Status screen will be
displayed as it sends your document to each selected destination.
When all destinations have been processed, the Processing
Review screen will be displayed.
NOTES:
• If Fast Scanning is enabled, these screens will not be displayed.
• This screen lists all the selected destinations (if you had more
than one). Successful destinations will be shown with a green
check mark. Unsuccessful destinations will be shown with a red
X, and the message, One or more saved destinations failed
will be displayed. To review detailed error messages, download
the error logs.