Kodak 500 - Manual (Page 19)

3-6 A-61628 December 2011
Installing the Kodak
Scan Station 500/
520EX - Scanner
Administration
application You must install the KSS500 - Scanner Administration application
(KSS500 - Scanner Admin) on a separate computer. The KSS500 -
Scanner Admin application allows you to properly setup, configure and
manage Scan Station 500 devices over a network in an efficient and
productive manner. This application communicates with Kodak Scan
Station 500 devices over the network; thereby minimizing individual
access to multiple Scan Stations.
1. Insert the Installation CD titled, “Scanner Administration and
Supporting Documentation” in the CD-ROM drive on the computer
where the KSS500 - Scanner Admin application will be installed.
The installation software starts up automatically.
NOTE: If .NET Framework 2.0 and MSI 3.x is not already installed,
the KSS500 - Scanner Admin application installer will install
them before installing the KSS500 - Scanner Admin
application.
2. Click Next when the Kodak Scan Station 500 splash screen is
displayed.
3. Click Next when the Welcome screen is displayed.
4. Click I Agree after you have read and agreed with the terms of the
Software License Agreement, then click Next.
5. When the Select Installation Folder screen is displayed, enter or
browse to, the folder where you want to install the KSS500 -
Scanner Admin application or keep the default setting. You may also
install the application for Everyone or Just Me (yourself), then click
Next.
NOTE: It is recommended that you accept the default settings.
6. Click Next on the Confirmation screen. The installation will start and
several progress screens will be displayed.
7. Click Close when the installation is complete.
8. Remove the Installation CD from the CD-ROM drive.