Kodak 500 - Manual (Page 132)

7-2 A-61628 December 2011
Cleaning procedures Your Scan Station needs to be cleaned periodically. If your documents
do not feed easily, if several documents feed at the same time or if
streaks appear on your images, it is time to clean your Scan Station.
The section entitled, “Supplies and consumables” at the end of this
chapter provides a listing of the supplies required to clean your Scan
Station.
IMPORTANT: Use only non-flammable cleaners such as those provided
through Kodak Parts Services. Do not use household
cleaners.
Allow surfaces to cool to ambient temperature before
use. Do not use cleaners on hot surfaces.
Use adequate ventilation. Do not use cleaners in
confined areas.
Do not use air, liquid or gas spray cleaners. These
cleaners displae dust, dirt and debris to other locations
within the Scan Station.
NOTES:
• Before beginning cleaning procedures, turn the Scan Station power
off and disconnect the electrical power.
• Wash your hands with soap and water after performing maintenance
procedures.
Cleaning the rollers 1. Open the Scan Station cover.
2. With a roller cleaning pad, wipe the feed rollers from side to side.
Rotate the feed rollers to clean the entire surface.
IMPORTANT: The roller cleaning pad contains sodium lauryl ether
sulfate which can cause eye irritation. Wash your hands
with soap and water after performing maintenance
procedures. Refer to the MSDS for more information.
3. Dry the rollers with a lint-free cloth.