Configuring your scan station – Kodak 500 User Manual
Page 31
3-18
A-61628 December 2011
Configuring your
Scan Station
This section provides the steps needed to configure your Scan Station.
Before you begin, you need to know some basic information about your
network configuration as well as network addresses (e.g., your Email
server and any shared folders you may want to access from your Scan
Station). Refer to the Pre-Installation Checklist in Chapter 2 as you are
configuring your Scan Station.
NOTE: Use the scroll arrows on the side and top of each screen to
display all options.
1. Double-click the KSS500 - Scanner Admin icon on your desktop to
launch the application.
2. Select File>Configuration Organizer. The main Configuration
Organizer window will be displayed.
3. Click Settings.
NOTE: Some of the settings described in this section may have been
setup previously when you first installed your Scan Station,
therefore, it is not necessary to reset any of these options
unless you want to make a change.