Kodak 500 - Manual (Page 25)

3-12 A-61628 December 2011
Network
configuration options Before you can start adding Scan Stations you must know the IP
address or the Scan Station’s device name; preferably both.
Whether you are administrating a Scan Station that is located next to
you or across the country on the same network, you must have this
information before administering a Scan Station using the KSS500 -
Scanner Admin application.
To get the name of your Scan Station:
1. Be sure the Scan Station is on and the application is running.
2. Click on the Information icon to display the Scan Station’s name or
IP address if the network has DHCP enabled.
If your Scan Station is currently connected to a network, the About
screen will also display the IP address that has been assigned to your
Scan Station.
Adding a Scan
Station Before adding Scan Station 500 devices to manage remotely, it is
suggested that you obtain the Scan Station name(s) and/or IP
addresses and passwords of the Scan Stations you want to add. You
must enter either a Scan Station name or IP address or both.
NOTE: The Scan Station will only have an IP address if the Scan
Station is connected to a network and has been configured.
As Scan Stations are added, the main screen will be updated.
1. Select Edit>Add Scanner. The Add Scanner dialog box will be
displayed.
2. Enter the name of the Scan Station in the Scanner Name field.
NOTE: Acceptable values in this field are: alphanumeric characters
and a dash. No spaces or other symbols are allowed.
3. Enter the IP address. The IP address must be in IPv4 format
xxx.xxx.xxx.xxx.