Kyocera FS-5900C - Manual (Page 107)

94
Care and Maintenance
Error Message Possible Cause Corrective Action
I/F occupied The front control panel
operation you attempted
is not possible because
that interface is receiving
data. Wait until the data transfer is
completed on that interface.
Imaging unit
not locked
The imaging unit is not
locked properly because
its lever is not lifted. Lift the imaging unit lever
fully up.
Insert the same
MEMORY CARD
A different memory card
was inserted following the
MEMORY CARD err/
Insert again message.
Reinsert the same memory
card as was removed previous-
ly into the printer’s memory
card slot.
KPDL Error ##
Press CONTINUE
The printer encountered
an error during process-
ing data in KPDL mode. Note the error code of ## and
press
CONTINUE to clear the
error situation. See section
KPDL Error Codes (☞ P. 100)
for information.
Left cover Open The left side cover is open. Close it tightly.
Load (paper source)
(paper size)(media type)
The paper size or type
does not match the
printing area. One of MP tray , Cassette 1
to 3 , will be displayed in
place of "paper source". Load
the paper displayed on the
message display and press the
CONTINUE key to print.
Or, pressing the FEED key
without pressing the CONTIN-
UE key, will cause Use al-
ternative ? to be displayed,
and a different paper source
can be selected to supply
paper. The paper source
changes each time the
FEED
key is pressed. And press the
MODE key to display Paper
handling >. Press the key
and you can change the paper
source setting using the + or -
key to select. Load paper
appropriate for the paper
source and press the
EXIT key
to print.