Kyocera FS-5900C - Manual (Page 67)

54
Using the Printer
■ Print Accumulated VMB Data with a Password
This function prints VMB data protected by a password which has accumulated in a
virtual output tray.
1 Display >Print VMB data Tray. The VMB tray number will appear
in the location marked by #’s below, while the VMB tray name will
appear in the location marked by %’s.
>Print VMB data
Tray###:%%%%%%%
2 Pressing the ENTER key will cause a ? to flash.
>Print VMB data
Tray###?%%%%%%%
3 Each time the + or - keys are pressed, the VMB data display will
change. Press the CANCEL key if you want to halt printing. The ?
display will disappear.
4 If a password is set for the VMB data you want to print, the message
display will change to >User ID? 00001 and the printer will standby
to accept a password. The cursor will blink in the one’s place of the
displayed number. Enter the correct password. Use the and
keys to change places and the + or - keys to change the displayed
number. Passwords from 00001 to 65535 can be entered.
5 Press the ENTER key once the correct password is entered.
Processing will be displayed and the data will be printed. If the
password was incorrect, an error message “RAM DISK error 86” will
be displayed. (See page 97) Pressing the CONTINUE key will return
the printer to Ready status.
Note that the password entered here is reset (returns to 00001) when this mode is exited.