Kyocera FS-5900C - Manual (Page 110)

97
Care and Maintenance
Error Message Possible Cause Corrective Action
RAM DISK error ##
Press CONTINUE
Check the error code
displayed in the place of
## and refer to the
corresponding description
at right. 01: Abnormal format. Try
turning the power off and on
again.
02: RAM DISK mode is OFF.
Turn RAM DISK mode On.
03: Cannot write to the disk
system because it is write
protected. Remove the write
protection.
04: No disk space. Clean up
files.
05: Specified file not on disk.
06: No memory for use by disk
system. Expand printer
memory.
10: Cannot format disk be-
cause host data is spooled
there. Format the disk after
Ready is displayed.
85: VMB: Alias error (Alias
setting failure or no virtual bin
corresponds to the alias.)
Make the setting again.
86: VMB: Password error (No
password specification, mis-
taken password, or password
setting failure.)
Check the password.
87: VMB: Although an attempt
was made to use a virtual bin
job stack, the stack size
reached the maximum limit.
Output the job or raise the
maximum limit.
88: VMB: There was a job or
page which could not be read
out during virtual bin job
output (the job is destroyed).
89: VMB: No job in the virtual
bin specified for output or that
virtual bin is not being used.
Check the bin.
97: MPS: A non-volatile job
has reached the maximum
limit and no more data can be
saved. Clean up the job or
raise the maximum limit.
98: MPS: There was a page
which could not be read out
within a job (the job is de-
stroyed).