Kyocera FS-5900C - Manual (Page 109)

96
Care and Maintenance
Error Message Possible Cause Corrective Action
Missing Toner
TD-81Y (Yellow)
The yellow toner develop-
er is not installed in the
printer. Install the yellow toner
developer (☞ P. 14).
Missing paper
feed unit
The paper feeder unit is
not installed in the
printer. Install the paper feeder unit.
Option feeder
Left cover Open
The paper feeder’s left
side cover is open. Close it tightly.
Opt. ROM error
Press CONTINUE
The printer has encoun-
tered an error while
accessing data in the
option EPROM (on the
printer main board). Press CONTINUE to print the
data processed so far. Replace
the option EPROM.
Option interface
Error ##
The printer has detected
an error on the option
interface. Note the error code of ## and
consult your Kyocera dealer.
Output tray
paper full
The output tray has
become full. Remove paper from the output
tray.
PJL OPMSG/STMSG The printer encountered
an error during process-
ing PJL commands. Press CONTINUE to print the
page processed so far.
Paper jam
(Location)
Paper has become
jammed. Remove jammed paper accord-
ing to section Removing Paper
Jam (☞ P. 71).
Print overrun
Press CONTINUE
The printer has received
print data that is too
complex to finish process-
ing in time with the
operation of the printer
mechanism. Press CONTINUE to print the
data. Install additional
memory .
Processing
PAR FIT A4
Compressed data is
printed due to insufficient
memory when FIT flashes
in the resolution indica-
tor. The quality of printed
data is reduced when this
occurs. Fit will continue
flashing even after
printing is finished. The
resolution indicator will
automatically return to
the previous resolution
when any key is pressed,
when a timeout occurs, or
when subsequent data is
received. Increase the printer memory
to avoid this error.