KVH Industries TracVision G8 - Manual (Page 105)

5.12 Replacing the Azimuth Belt
1. Cut and discard the old belt.
2. Cut the tie-wraps securing the spare belt to the antenna
frame.
Figure 5-19 Spare Azimuth Belt Attached to Frame
3. Carefully work the spare belt around the azimuth motor
hub and around the azimuth pulley. Ensure that the teeth
are on the inside of the belt. Once the belt is in place,
work it back and forth to ensure that the belt is aligned
and the teeth are engaged with the pulley and motor hub.
Ensure that the belt fits tightly around the pulley and hub.
(To tighten the belt, loosen the azimuth motor’s #8-32
locking nuts, slide the motor until the belt is tight, then
retighten the locking nuts.)
Figure 5-20 Azimuth Belt
Maintenance
54-0198 109
Spare Belt
#8-32 Locking Nuts (x 4)
Motor Hub
Azimuth Belt
Azimuth Pulley