KVH Industries TracVision G8 - Manual (Page 94)

5.4 Accessing Antenna Components
Through the Hatch
You can access all field replaceable units through the large hatch
on the antenna baseplate. You do not need to remove the
radome. To remove the hatch cover, simply remove the eleven
M4 screws securing the hatch cover to the baseplate.
Figure 5-3 Baseplate Access Hatch
5.5 Replacing the PCB Module Fuse
The PCB module is equipped with a 5-amp, 125-volt fast-blow
fuse. If this fuse has blown or been broken, simply unscrew the
fuse holder cap on the PCB module and replace the fuse.
Figure 5-4 PCB Module Fuse Location
54-0198 98
TracVision G8 Owner’s Manual - Guide to Technical Information
M4 Screws
(x 11)
Fuse Holder Cap