KVH Industries TracVision G8 - Manual (Page 50)

54-0198 48
TracVision G8 Owner’s Manual - Guide to Technical Information
4. Repeat Step 3 for each of the following transponder
categories:
• vertical high • vertical low
• horizontal high • horizontal low
OR
• right • left
TracVision G8 requires that the data fields for all
transponder categories be provided. If the selected
satellite does not have information for one or more of the
transponder categories, default information should be
entered in the fields as follows:
Transponder Data Default Value
Frequency 00000
Symbol Rate 27500
FEC Code the same value as provided for those
transponders with data
Network ID 0x0000
Polarity and Band whichever combinations are not
already provided
5. Type ZAP<Enter> to restart the antenna.
6. If you need to configure a second user-defined satellite,
repeat this procedure starting with Step 1 to enter data for
the USER2 satellite.
You have now added your user-defined satellite(s) to the
system’s satellite library.
If you want the antenna to track one or both of these user-defined
satellites, you need to install it. To install a satellite, you can use
either the MCU, as described in “Installing Your Selected Satellites”
on page 43, or you can use the SATINSTALL command, as
described on the following page.