KVH Industries TracVision G8 - Manual (Page 51)

Installation
54-0198 49
1. Type HALT<Enter> to put the antenna in Idle mode.
2. Enter the SATINSTALL parser command as follows:
Command: SATINSTALL,<satA_name>,<satB_name><Enter>
Where: <satA_name> = the name of your choice for
Satellite A (for example: USER1)
<satB_name> = the name of your choice for
Satellite B (for example: USER2)
If you only want to install and track one satellite, enter
NONE as the name of Satellite B.
3. Once you’ve assigned satellites as Satellite A and Satellite
B, you need to tell the antenna which of the two satellites
it should initially acquire and track. This step should be
performed the first time a satellite is selected, allowing
the system to download the channel guide. To do so, enter
the following parser command:
Command: @L,A or B<Enter>
Where: A = track Satellite A
B = track Satellite B
4. Type ZAP<Enter> to restart the antenna.
Examples of the user-defined satellite configuration process are
provided for reference in the next two sections.
European systems only:
If DiSEqC is active on your
receiver, once the antenna restarts,
the antenna starts tracking the
satellite currently selected by the
receiver, overriding the @L
command.