KVH Industries TracVision G8 - Manual (Page 45)

Installation
54-0198 43
Latin America
In Latin America, choose one of the satellites listed below for
DIRECTV Latin America (DLA) service (DLA circular dual LNB
required).
Australia
In Australia, you can pair together the two satellites listed below
(Linear quad LNB/feed tube assembly required).
The satellites listed in TracVision G8’s preprogrammed satellite
library will be sufficient for most users. However, if you wish to
install one or two satellites that are not in the library, skip to
“Programming User-defined Satellites” on page 45. After configuring
these user-defined satellites, return to the satellite installation
process in “Installing Your Selected Satellites” below.
Installing Your Selected Satellites
To install your selected satellites as Satellite A and Satellite B,
follow the steps below.
1. Apply power to the MCU.
2. Following the startup sequence, press the center button to
bring up the “Install Satellite?” screen.
Figure 2-22 Install Satellite Screen
3. Follow the process shown in Figure 2-23 on the following
page to install your selected satellites. At the end of the
process, be sure to press the YES button to restart the
antenna.
Install Satellite?
Enter Next Return
Section 3, “Using the MCU
Interface,”
provides complete details
on the use of the MCU menus,
including complete antenna control
details in “Control Antenna Mode”
on page 67.
• Galaxy3CN • Galaxy3CS
• Optus_B1 • Optus_B3