KVH Industries TracVision G8 - Manual (Page 37)

2.4 Wiring the MCU
All other wiring for the TracVision system connects at the rear
panel of the MCU.
For the TracVision system to work properly, you must connect
the following cables to the MCU:
• Antenna data/power cable
• Vessel power cable
Figure 2-16 shows the MCU’s rear panel connectors. Refer to this
figure when wiring components to the MCU.
Figure 2-16 MCU Rear Panel
Connecting the Antenna Data/Power Cable
Connect the antenna data/power cable to the data/power
connector on the MCU’s rear panel (see Figure 2-16). Do not
overtighten; finger-tight is sufficient.
Installation
54-0198 35
Antenna
Data/Power
Vessel Power
+ -
Maintenance Port
(for PC diagnostics)
RF PCB Software Flashing Port
(technician’s use only)
Fuse MCU Ground Wire