KVH Industries TracVision G8 - Manual (Page 128)

Maintenance Port Antenna Commands
54-0198 135
Set RF Tracking Parameters
Function: sets RF tracking parameter
Command: @SATCONFIG,X,N,F,S,C,ID,P,B,D<cr>
Response: Echoes the input data
Where: @SATCONFIG = directs data to the RF Board
X = satellite A or B
N = satellite table # (98 & 99 are slots for user-
configured satellites)
F = frequency in MHz (either 00000 or a range from
10700 - 12700)
S = the satellite transponder symbol rate in
Mbit/second (01000 - 29999)
C = the FEC code (e.g., 12, 23, 34, 56, 67, 78)
ID = the satellite network ID in hexidecimal format
(0x####)
P = the LNB polarization (V = vertical,
H = horizontal, R = right, L = left)
B = the LNB down conversion frequency (L = low,
H = high, G = Latin America, U = USA)
D = decoding type (1 = DSS-A, 2 = DSS-B,
3 = DVB)
ID Match/Decoded Network ID
Function: report ID match and decoded network ID
Command: @CHECKID
Response: one of the following:
Y,0X####
N,0X####
Y,NoID
N,NoID
N,NoLock
Where: Y = yes
N = no
0X#### = network ID
NoID = satellite unidentified
NoLock = satellite not found