KVH Industries TracVision G8 - Manual (Page 112)

12. Reconnect the motor cable that you removed in Step 6.
13. Apply a small amount of Loctite threadlocker to the
threads of the four #8-32 screws that you removed in
Step 5.
14. Carefully reattach the LNB/feed tube assembly to the
antenna reflector and secure in place with the four #8-32
screws.
15. Apply a small amount of Loctite threadlocker to the
threads of the two #8-32 set screws that you loosened in
Step 4.
16. Carefully insert the feed tube into the feed tube assembly
collar and secure in place with the #8-32 set screws.
17. Reconnect the cables you removed in Steps 1, 2, and 3.
5.16 Replacing the Skew Belt
(Linear Quad LNB Systems Only)
1. Follow Steps 1 through 5 of the previous section.
2. Using a 2.5 mm allen wrench, loosen (do not remove) the
four M3 cap screws securing the motor to the bracket
until the motor is free to slide back and forth. Slide the
motor toward the pulley to loosen the belt.
Figure 5-31 Skew Motor and Belt
54-0198 116
TracVision G8 Owner’s Manual - Guide to Technical Information
Pulley
Motor Hub
M3 Cap Screws
and #4 Washers
(x 4)
Motor Cable
Connector
Motor Cable
Skew Belt