KVH Industries TracVision G8 - Manual (Page 93)

All field replaceable units may be removed and replaced on site
using common hand tools. Other service must be done by your
authorized dealer/installer, distributor, or by KVH. Evidence of
tampering or unauthorized repairs will void the warranty.
The following sections provide step-by-step procedures for
replacing field replaceable units. Figures 5-1 and 5-2 show the
locations of a number of components within the antenna unit.
Figure 5-1 TracVision G8 Antenna Unit (Front View)
Figure 5-2 TracVision G8 Antenna Unit (Rear View)
Maintenance
54-0198 97
TracVision G8 components
receive power from multiple
sources. Do not open any
electrical assemblies or attempt
servicing until receiver power
and vessel input power are
disconnected.
PCB Module
Feed Tube
Reflector
LNB
Baseplate
Internal
Sensor
(w/ GPS)
Skew Motor
(Linear Quad only)
Azimuth
Motor
Frame
Elevation
Motor