KVH Industries TracVision G8 - Manual (Page 29)

6. Remove the eight screws securing the radome to the
baseplate. Carefully lift the radome straight up until clear
of the antenna assembly and set it aside in a safe place. If
you bring the radome topside, secure it with a lanyard to
prevent it from falling overboard.
7. Remove the tie-wrap securing the MCU/kitpack box to
the antenna baseplate. Remove the box.
Figure 2-4 MCU/Kitpack Box
8. Inspect the antenna unit for any signs of shipping
damage.
9. Position the baseplate assembly in place over the
mounting holes, with the baseplate’s connectors (shown
in Figure 2-5) facing the stern. Ensure that all mounting
holes line up and make any necessary adjustments.
Figure 2-5 Location of Baseplate Connectors
Installation
54-0198 27
Tie-wrap
Connectors