Kenwood DVF-J6050 - Manual (Page 14)

14
Chapter 1: Connection of Equipment
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
C : Component video connection
If the TV has component video input terminals, connect the Y, C B and C R COMPO-
NENT VIDEO OUTPUT terminals to the corresponding jacks on the TV using video
cables.
¶ As component video separate video signal into the brightness signal (Y) and
color difference signals (C B , C R ), it can provide sharper image than the S Video
connection.
¶ Depending on the TV or video monitor in use, the terminal names may be
different from those used with the player (Y/Pb/Pr or Y/B-Y/R-Y, etc.)
¶ When the TV in use is a HDTV or "Hi-Vision" TV, connect the component video
signals from the player only to the DVD-compatible input jacks.
1
2
2 1
COMPONENT VIDEO S VIDEO VIDEO
OUTPUT
INPUT INPUT
Y C B C R Y C B C R
OUTPUT OUTPUT
INTERLACE PROGRESSIVE
COMPONENT
VIDEO
OUTPUT
COMPONENT
VIDEO IN
Y Cb Cr
Video cable
d : SCART connection (For Europe and U.K.)
If the TV or VCR has SCART connectors, connect the TV SCART or VCR SCART
connector of this unit to the TV or VCR using SCART cables.
¶ The audio and video signals can be output using a single cable. The signal output
from the TV SCART connector can be switched between composite video, S
Video and RGB. (The VCR SCART connector always outputs composite video
signals so its output signals cannot be selected.)
¶ When the TV is connected through a VCR using SCART connection, the picture
displayed on the TV may be disturbed due to the copy protect function.
¶ When using only the TV and VCR which are both connected with the player
using the SCART connection, the signal from the VCR cannot be sent to the
TV if the player is switched off. (In this case, set the player to the power
standby mode.)
¶ When the COMPONENT VIDEO OUTPUT connectors are used, do not set
“SCART Output Select” in the Set Up menu to “RGB”. F
DIGITAL D A I S Y C H A I N A U D I O C O M P O N E N T V I D E O
6 C H . I N P U T M I X L I N E (PCM/BIT STREAM)
T V S C A RT
V C R S C A RT
S C A RT I N
S C A RT I N
SCART cable
SCART cable
VCR etc.
COMPONENT VIDEO OUTPUT switch (NTSC Format only)
I N P U T O U T P U T
COMPONENT
VIDEO
OUTPUT
S V I D E O V I D E O
O U T P U T
INTERLACE PROGRESSIVE
1 1 2
2
Select the scanning method of the Component Video output
using the COMPONENT VIDEO OUTPUT switch on the rear
panel.
INTERLACE : Scanning method is fixed at interlaced scanning.
PROGRESSIVE : When progressive scanning is unavailable with
certain discs, the scanning method is switched automatically to
interlaced scanning. When the unit is performing progressive
scanning, “PROGRESSIVE” light in the display.
Illust Model : DV-5900M