LG C Series - Manual (Page 33)

Chapter 5. Programming keypad
z Changing parameter values in Function 1, 2 and I/O group
When changing the parameter value of F 27 from 2 to 5
Function
group 1
1 -. In F0, press the Prog/Ent ( z) key once.
2
-. Check the present code number.
-. Increase the value to 7 by pressing the Up (
S) key.
3 -. When 7 is set, press the Left (
W) key once.
4
-. 0 in 07 is active.
-. Increase the value to 2 by pressing the Up (
S) key.
5
-. 27 is displayed
-. Press the Prog/Ent (
z) key once.
6
-. The parameter number F27 is displayed.
-. Press the Prog/Ent (
z) key once to check the set value.
7
-. The set value is 0.
-. Increase the value to 1 by pressing the Up (
S) key.
8 -. Press the Prog/Ent ( z) key once.
9
-. F27 is displayed after 5 stops blinking. Changing parameter value has been
complete.
-. Press the either Left (
W) or Right (X) key once to go to the first code.
10 -. Return to F0.
♣ The above setting is also applied to change parameter values in function group 2 and I/O
group.
33